Suspension clamp
Jun 14,2019hits:1525

  

AGS BOLT,WASHER,LOCK NUT: Galvanized Steel.
AGS STRAP: Galvanized Steel for conductor dia. range 6.7~12.7mm. High-Strength Aluminum Alloy for conductor dia. range 12.24~56.7mm.
AGS INSERT: An elastomer specifically formulated for resistance to ozone attack, weathering, extreme high and low temperature variations, and compression set. An aluminum alloy reinforcement  is molded into the elastomer.             
AGS HOUSING: Galvanized Steel Stamping – for cable dia. range 6.9~12.7 mm High-Strength Aluminum  Alloy Casting for conductor dia. range 12.24~56.7mm.
AGS RODS:Aluminum Clad Steel for ACSR diameter 12.24~56.7mm. Aluminum Alloy for CSR diameter 12.24~56.71mm. Aluminum Clad Steel for Alumoweld Strand diameter 6.7~12.7mm. Galvanized Steel for Galvanized Steel Strand, diameter 6.9~12.7mm. Standard Armor Rods have dimensions which are different from AGS Rods and cannot be substituted.
AGS RODS:  Aluminum Clad Steel for ACSR diameter 12.24~56.7mm. Aluminum Alloy for CSR diameter  12.24~56.71mm. Aluminum Clad Steel for Alumoweld Strand diameter 6.7~12.7mm. Galvanized Steel for Galvanized Steel Strand, diameter 6.9~12.7mm. Standard Armor Rods  have dimensions which are different from AGS Rods and cannot be substituted.

GENERAL RECOMMENDATIONS:
1,ARMOR-GRIP Suspension is intended for use on aluminum based conductors, Alumoweld and galvanized steel strands. It is designed to reduce the static and dynamic stresses at the support point, so that the conductor or strand is protected against the effects of oscillations. It also protects the conductor in the support against impulse and power flash-over. ARMOR-GRIP  Suspension is recommended as being superior to armor – clamp combinations, for protecting conductors from bending stress, compression stress and abrasion.
2,This product is intended for a single (one-time) use and for thespecified application. However, all components, except the rod, may be reused if in good condition.
CAUTION: DO NOT MODIFY OR REUSE THE RODS UNDER ANY CIRCUMSTANCES.

Considerations:
Our products are intended for use by trained craftspeople only.
1.This product SHOULD NOT BE USED by anyone who is not familiar With and trained in the use of it.
2.when working in the area of energized lines with this product,EXTRA CARE should be taken to prevent accidental electrical contact.
3.For PROPER PERFORMANCE AND PERSONAL SAFETY be sure toSelect the proper type and size PREFORMED Product before application.
4.PREFORMED products are precision devices.To insure proper performance,They should be stored in cartons under cover and handled carefully.